TUFLOW Message 2022: Difference between revisions
Jump to navigation
Jump to search
Content deleted Content added
No edit summary |
No edit summary |
||
| Line 3: | Line 3: | ||
|alt_msg=NA |
|alt_msg=NA |
||
|type=[[ERROR]] |
|type=[[ERROR]] |
||
|message_desc=Can only use <font color="blue"><tt>Oblique Boundary Alignment </tt |
|message_desc=Can only use <font color="blue"><tt>Oblique Boundary Alignment </tt></font><font color="red"><tt>== </tt></font>NEAREST TO LINE </tt></font> for 2D BC if <font color="green"><tt>Oblique Boundary Method == ON</tt></font>.<br> |
||
As of Build 2006-06-AA, this command is considered redundant (other than for backward compatibility), as the Method C or D (Boundary Cell Selection and Line Cell Selection) ensures that the same cells are selected along both HX lines and Z lines. |
As of Build 2006-06-AA, this command is considered redundant (other than for backward compatibility), as the Method C or D (Boundary Cell Selection and Line Cell Selection) ensures that the same cells are selected along both HX lines and Z lines. |
||
|suggestions=If using a build of TUFLOW prior to 2006-06-AA and using the <font color="green"><tt>Oblique Boundary Alignment == NEAREST TO LINE </tt></font> command, ensure that the <font color="green"><tt>Oblique Boundary Method == ON</tt></font> command is also used. |
|suggestions=If using a build of TUFLOW prior to 2006-06-AA and using the <font color="green"><tt>Oblique Boundary Alignment == NEAREST TO LINE </tt></font> command, ensure that the <font color="green"><tt>Oblique Boundary Method == ON</tt></font> command is also used. |
||
Revision as of 09:05, 24 June 2022
TUFLOW Message
ERROR 2022 - Can only use nearest to line oblique boundary alignment for 2D BC if "Oblique Boundary Method == ON"
Alternate Message
NA
Message Type
ERROR
Description
Can only use Oblique Boundary Alignment == NEAREST TO LINE for 2D BC if Oblique Boundary Method == ON.
As of Build 2006-06-AA, this command is considered redundant (other than for backward compatibility), as the Method C or D (Boundary Cell Selection and Line Cell Selection) ensures that the same cells are selected along both HX lines and Z lines.
Suggestions
If using a build of TUFLOW prior to 2006-06-AA and using the Oblique Boundary Alignment == NEAREST TO LINE command, ensure that the Oblique Boundary Method == ON command is also used.
| Up |
|---|
 2xxx Messages
|