TUFLOW Message 2204: Difference between revisions
Jump to navigation
Jump to search
Content deleted Content added
No edit summary |
No edit summary |
||
| Line 6: | Line 6: | ||
|suggestions=Check the connectivity of the HX line. Ensure that the HX is either connected to an ESTRY 1D channel with CN lines or an ISIS not directly or with an X connector. |
|suggestions=Check the connectivity of the HX line. Ensure that the HX is either connected to an ESTRY 1D channel with CN lines or an ISIS not directly or with an X connector. |
||
|prelink=[[TUFLOW_Message_2202|Message 2203]] |
|||
|uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] |
|uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] |
||
|nextlink=[[TUFLOW_Message_2205|Message 2205]] |
|||
}} |
}} |
||
Revision as of 14:04, 7 February 2023
TUFLOW Message
ERROR 2204 - Could not assign ISIS unit node to 2D HX cell. Check that HX line is not also connected to TUFLOW 1D Node.
Alternate Message
NA
Message Type
ERROR
Description
TUFLOW could not connect the HX cells to the ISIS unit. This may occur if the HX line is already connected to an ESTRY 1D channel
Suggestions
Check the connectivity of the HX line. Ensure that the HX is either connected to an ESTRY 1D channel with CN lines or an ISIS not directly or with an X connector.
| Up |
|---|
 2xxx Messages
|