TUFLOW Message 1510: Difference between revisions
Jump to navigation
Jump to search
Content deleted Content added
Steph.dufour (talk | contribs) Created page with "{{TUFLOW_Message |tuflow_message=CHECK 1402 - More than one culvert connected but could not create manhole at Node <Node ID> |alt_msg=NA |type=CHECK |message_desc=When app..." |
Steph.dufour (talk | contribs) No edit summary |
||
| Line 1: | Line 1: | ||
{{TUFLOW_Message |
{{TUFLOW_Message |
||
|tuflow_message= |
|tuflow_message=ERROR 1510 - Invalid condition specified in operating control rule below. |
||
|alt_msg=NA |
|alt_msg=NA |
||
|type=[[ |
|type=[[ERROR]] |
||
|message_desc=???? |
|||
|message_desc=When applying the Engelhund loss approach for manholes (see Section 4.5.2 of the 2010 TUFLOW manual), if an incoming culvert enters above the obvert of the highest outlet, the culvert is not included in the manhole loss calculations. If there is only 1 incoming pipe with the invert above the obvert of the outlet culvert, the incoming culvert is ignored and with no inlet culvert to the node a manhole is not possible. See also point 48(b) in the [http://www.tuflow.com/Download/TUFLOW/Releases/2012-05/Doc/TUFLOW%20Release%20Notes.2011-09%20and%202012-05.pdf release notes]. |
|||
|suggestions=???? |
|||
|suggestions=Review the inverts on the culverts. A point object in a "1d_mh" layer can be used to set the loss approach at each manhole. |
|||
|discussion_page=* [[Talk:TUFLOW Message 1510|Discuss Message 1510]] |
|discussion_page=* [[Talk:TUFLOW Message 1510|Discuss Message 1510]] |
||
|link3='' |
|link3='' |
||
Revision as of 09:22, 3 February 2015
TUFLOW Message
ERROR 1510 - Invalid condition specified in operating control rule below.
Alternate Message
NA
Message Type
ERROR
Description
????
Suggestions
????
| Up |
|---|
 1xxx Messages
|