Difference between revisions of "TUFLOW Message 1301"

Revision as of 12:55, 28 April 2016

TUFLOW Message
ERROR 1301 - No ESTRY nodes found.

Alternate Message
NA

Message Type
ERROR

Description
No 1D nodes have been found.

Suggestions
This error message should only occur for a 1D or 1D/2D model. TUFLOW will check for 1D nodes if:

An ESTRY control file (.ecf) has been specified; or
Any 1D commands have been specified in the .tcf.

For example the following command in the .tcf will trigger a check for 1D nodes: "1D Output Folder == <output location>"
If you are encountering this message for a 2D only model, please remove 1D commands from the control files.

For a model with a 1D component, check that:

Automatic 1D node creation is turned on and 1D channels have been specified
If manually specifying 1D nodes, make sure these are being read in correctly.

Up
1xxx Messages

@@ Line 4: / Line 4: @@
 |type=[[ERROR]]
 |message_desc=No 1D nodes have been found.
-|suggestions=Ensure automatic 1D node creation is turned on, or if manually specifying 1D nodes, make sure these are being read in correctly.
+|suggestions=This error message should only occur for a 1D or 1D/2D model.  TUFLOW will check for 1D nodes if:<br>
+* An ESTRY control file (.ecf) has been specified; or
+* Any 1D commands have been specified in the .tcf.<br>
+For example the following command in the .tcf will trigger a check for 1D nodes: <tt>"1D Output Folder == <output location>"</tt><br>
+If you are encountering this message for a 2D only model, please remove 1D commands from the control files.<br>
+<br>
+For a model with a 1D component, check that:<br>
+* Automatic 1D node creation is turned on and 1D channels have been specified
+* If manually specifying 1D nodes, make sure these are being read in correctly.
 |discussion_page=* [[Talk:TUFLOW Message 1301|Discuss Message 1301]]
 |link3=''

Difference between revisions of "TUFLOW Message 1301"

Revision as of 12:55, 28 April 2016

Navigation menu

Search