TUFLOW 2D Cell Size Selection

This page is currently under construction.

Introduction

This page of the TUFLOW Wiki discusses 2D cell size convergence. Cell size convergence refers to the tendency for model results to trend towards a common answer as cell size decreases. This behaviour occurs due to topographic features that influence the hydraulic flow behaviour better approximating reality as resolution increases. The series of creek cross-section images below demonstrate this. As model resolution increases from 20m to 5m the modelled topography progressively matches the real-world geometry more closely.

Unfortunately it isn't practical for all models to be designed at an infinitely fine resolution due to the cost it has on simulation speed. Increasing a model resolution will make a simulation run slower. As a rule of thumb, halving the cell size in a model will typically increase the simulation run time by a factor 8. This is due to the number of cells increasing by a factor of (4) four and the necessity for a calculation timestep half that of the larger resolution, translating to (2) twice the number of calculations (4 x 2 = 8). The challenge for modellers is knowing what resolution is necessary to achieve results that are fit for purpose with sufficient accuracy. This Wiki page uses two test cases to discuss this topic.

Test Case 1

This test case has been sourced from the UK Environment Agency 2D Hydraulic Model Benchmark Test dataset. It is referred to as Test 5 in the Environment Agency (EA) dataset. The EA designed to simulate flood wave propagation down a river valley following the failure of a dam. The valley DEM is ~0.8 km by ~17 km and the valley slopes downstream on a slope of ~0.01 in its upper region, easing to ~0.001 at lower elevations. The model uses a single manning n value of 0.04 across the entire domain. The model topography, EA reporting points and the simulation inflow hydrograph is shown below.

The model has a single inflow at the top of the catchment.

The water flows downhill through the respective EA reporting points. Reporting location 4 and 5 are at the bottom of the model, furthest from the inflow locations.

The EA benchmark testing original assumed a 50m cell resolution. For the purpose of this assessment a range of cell sizes have been used to determine the impact changing grid resolution has on the model result. The following grid resolutions were used:

• 10m resolution (188240 cell count)
• 20m resolution (47080 cell count)
• 50m resolution (7540 cell count)
• 100m resolution (1880 cell count)
• 150m resolution (840 cell count)
• 200m resolution (480 cell count)

Test Case 1 - Results

Test results have focused on reporting locations 4 and 5. Their location furthest downstream makes them most sensitive of all 7 reporting locations. Any divergence in result due to poor representation of the upstream topography will accumulate, amplifying the result difference associated with a change in cell resolution.

Cell Size	Location 4 Result	Location 5 Result	Mesh Resolution Figure
10m
20m
50m
100m
150m
200m
250m