Revision as of 19:17, 14 December 2018 view source Tuflowduncan (talk \| contribs) Bureaucrats, Administrators 1,222 edits →Method ← Older edit		Revision as of 00:28, 19 December 2018 view source Tuflowduncan (talk \| contribs) Bureaucrats, Administrators 1,222 edits →Method Newer edit →
Line 33: <li>The CN and HX lines between nodes FC02.06 and FC02.01d along the tributary have not been digitised. Digitise these lines to connect the nodes to the 2D domain.<br> To digitise the CN lines, make the <b> ~~2d_bc_FMT_M01_HX_001_L~~2d_bc_FMT_M01_HX_001.TAB </b> layer editable and ensure snapping is turned on. For each node in the '''1d_x1d_FMT_M01_nodes_001.TAB''' layer, draw a line from the node to the HX line. The line must snap to both the node and the HX line. Draw two lines for each node, one to the left bank and one to the right bank. In the 'Type' attribute of each line, type 'CN'. Assign the digitised CN lines an ‘f' attribute’ of ‘1’. This sets the weighting to be applied in distributing the water level from the 1D node to the 2D cell. <br> <br>The figure below shows how the nodes are connected at the confluence. Note that all Flood Modeller nodes at the junction are present within the 1d_x1D_nodes layer, and are connected to the 2D domain. The HX lines are broken around the junction. </li> <br>

FM Tute M01 MI 1D2D Links: Difference between revisions