Difference between revisions of "TUFLOW Message 0040"
Jump to navigation
Jump to search
| Line 11: | Line 11: | ||
If Scenario == 1974 | If Scenario == 1974 | ||
:Read GIS Shape == mi\2d_zsh_road_remove.mif | :Read GIS Shape == mi\2d_zsh_road_remove.mif | ||
| − | Else If Scenario == exg | OpA | + | Else If Scenario == exg <nowiki>|</nowiki> OpA |
:Read GIS Shape == mi\2d_zsh_road_exg.mif | :Read GIS Shape == mi\2d_zsh_road_exg.mif | ||
Else If Scenario == OpB | Else If Scenario == OpB | ||
Revision as of 11:18, 10 August 2011
TUFLOW Message
ERROR 0040 - No "End If" specified for "If Scenario == ",a,
Alternate Message
NA
Message Type
ERROR
Description
No End If command was found to close of the If Scenario == block.
Suggestions
Add the End If command where it is missing.
Tip: When using commands such as If Scenario == indent the commands within the block that follows as this makes it much easier to interpret which commands apply to which event definition. For example:
If Scenario == 1974
- Read GIS Shape == mi\2d_zsh_road_remove.mif
Else If Scenario == exg | OpA
- Read GIS Shape == mi\2d_zsh_road_exg.mif
Else If Scenario == OpB
- Read GIS Shape == mi\2d_zsh_road_OpB.mif
End Define
Other examples of commands that benefit from indenting are:
- Start 2D Domain ==
- If Scenario ==
| Up |
|---|
 0xxx Messages
|