Difference between revisions of "TUFLOW Message 2812"
Jump to navigation
Jump to search
| Line 3: | Line 3: | ||
|alt_msg=NA | |alt_msg=NA | ||
|type=[[WARNING]] | |type=[[WARNING]] | ||
| − | |message_desc=This warning occurs if a quadtree control file is specified, but only one quadtree nesting level | + | |message_desc=This warning occurs if a quadtree control file is specified, but only one quadtree nesting level is used. The quadtree mesh will be created with single level. |
|suggestions=Omit this warning if it is intended to use one level, or check if nesting should be applied. | |suggestions=Omit this warning if it is intended to use one level, or check if nesting should be applied. | ||
|discussion_page=* [[Talk:TUFLOW Message 2812|Discuss Message 2812]] | |discussion_page=* [[Talk:TUFLOW Message 2812|Discuss Message 2812]] | ||
Revision as of 16:22, 22 September 2020
TUFLOW Message
WARNING 2812 - No quadtree nesting, largest nesting level = 1.
Alternate Message
NA
Message Type
WARNING
Description
This warning occurs if a quadtree control file is specified, but only one quadtree nesting level is used. The quadtree mesh will be created with single level.
Suggestions
Omit this warning if it is intended to use one level, or check if nesting should be applied.
| Up |
|---|
 2xxx Messages
|