Revision as of 11:14, 21 July 2020 view source Pavlina Monhartova (talk \| contribs) Bureaucrats, Administrators 5,372 edits Created page with "{{TUFLOW_Message \|tuflow_message=CHECK 3520 - Found SGS cell face that has minimum Face elevation lower than the minimum cell centre elevations on both sides. \|alt_msg=NA \|typ..."		Revision as of 09:01, 23 September 2020 view source ShuangGao (talk \| contribs) Bureaucrats, Administrators 1,087 edits No edit summary Newer edit →
Line 1: {{TUFLOW_Message \|tuflow_message=CHECK 3520 - Found SGS cell face that has minimum Face elevation lower than the minimum cell centre elevations on both sides. \|alt_msg=Minimum U elevation must be higher than the minimum cell centre elevations on both sides in SGS. ZCmin left = "a", ZUmin = "b", ZCmin right = "c"<br> ~~\|alt_msg=NA~~ Minimum V elevation must be higher than the minimum cell centre elevations on both sides in SGS. ZCmin left = "a", ZUmin = "b", ZCmin right = "c" \|type=[[CHECK]] \|message_desc=SGS ~~cell~~model ~~face~~need ~~has~~to ~~minimum~~insure ~~Face~~every cell face elevation is NOT lower than the minimum cell centre elevations on both sides. The warning suggest discontinuity in sub-grid elevation, which can happen occasionally during pre-processing of Sub-Grid Sampling. If this happens, the cell face elevation will be increased automatically to insure simulation stability. \|suggestions=Check in _message_p layer where this is happening and which Zpts command is causing this. If the input layers are all correctly set, you can also turn "<font color="blue"><tt>SGS Face Elevation Warning</tt></font> <font color="red"><tt>==</tt></font> <tt>OFF</tt>" to omit this warning message. ~~\|suggestions=~~ \|discussion_page=* [[Talk:TUFLOW Message 3520\|Discuss Message 3520]] \|link3=''

TUFLOW Message 3520: Difference between revisions