TUFLOW Message 2074: Difference between revisions
Jump to navigation
Jump to search
Content deleted Content added
No edit summary |
No edit summary |
||
| Line 6: | Line 6: | ||
[[File:WARNING 2074.jpg|600px]] |
[[File:WARNING 2074.jpg|600px]] |
||
|suggestions=Check SA object and ensure that it is an active model area and selects at least one ZC zpt, or chose a different inflow location. |
|suggestions=Check SA object and ensure that it is an active model area and selects at least one ZC zpt, or chose a different inflow location. |
||
|discussion_page=* [[Talk:TUFLOW Message 2074|Discuss Message 2074]] |
|||
|link3='' |
|||
|link4='' |
|||
|prelink=[[TUFLOW_Message_2073|Message 2073]] |
|prelink=[[TUFLOW_Message_2073|Message 2073]] |
||
|uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] |
|uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] |
||
Revision as of 13:13, 6 July 2022
TUFLOW Message
WARNING 2074 - SA object does not select any 2D cells (active or inactive).
Alternate Message
NA
Message Type
WARNING
Description
SA object does not select any 2D cells (active or inactive). For example this could occur when a 2d_sa object is located outside of the active model area. This warning may also occur if the digitised SA polygon does not select any cell centres (ZC points), in the figure below the polygon highlighted in pink does not contain any cell centres and therefore this warning message will be returned.
Suggestions
Check SA object and ensure that it is an active model area and selects at least one ZC zpt, or chose a different inflow location.
| Up |
|---|
 2xxx Messages
|