Difference between revisions of "TUFLOW Message 2812"
Jump to navigation
Jump to search
| Line 6: | Line 6: | ||
|suggestions=Omit this warning if it is intended to use one level, or check if nesting should be applied. | |suggestions=Omit this warning if it is intended to use one level, or check if nesting should be applied. | ||
| − | |prelink=[[ | + | |prelink=[[TUFLOW_Message_2811|Message 2811]] |
|uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] | |uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] | ||
| − | |nextlink=[[ | + | |nextlink=[[TUFLOW_Message_2813|Message 2813]] |
}} | }} | ||
Revision as of 12:21, 16 December 2022
TUFLOW Message
WARNING 2812 - No quadtree nesting, largest nesting level = 1.
Alternate Message
NA
Message Type
WARNING
Description
This warning occurs if a quadtree control file is specified, but only one quadtree nesting level is used. The quadtree mesh will be created with single level.
Suggestions
Omit this warning if it is intended to use one level, or check if nesting should be applied.
| Up |
|---|
 2xxx Messages
|