Difference between revisions of "TUFLOW Message 3011"
| Line 2: | Line 2: | ||
|tuflow_message=ERROR 3011 - Target control number must be in range 0.001 - 1.2. | |tuflow_message=ERROR 3011 - Target control number must be in range 0.001 - 1.2. | ||
<br> | <br> | ||
| − | |alt_msg= | + | |alt_msg=NA |
| − | |||
|type=[[ERROR]] | |type=[[ERROR]] | ||
|message_desc=This error message has been deprecated. If you are still receiving this message with the latest TUFLOW release, please contact [mailto:support@tuflow.com support@tuflow.com].<br> | |message_desc=This error message has been deprecated. If you are still receiving this message with the latest TUFLOW release, please contact [mailto:support@tuflow.com support@tuflow.com].<br> | ||
Revision as of 13:18, 9 September 2024
TUFLOW Message
ERROR 3011 - Target control number must be in range 0.001 - 1.2.
Alternate Message
NA
Message Type
ERROR
Description
This error message has been deprecated. If you are still receiving this message with the latest TUFLOW release, please contact support@tuflow.com.
The Control Number Factor must be in the range 0.001 - 1.2.
Suggestions
Ensure the 'Control Number Factor' TCF command is within the range 0.001 - 1.2. The default value is 1.0.
Whilst it is possible to increase the default HPC Courant, shallow wave celerity and diffusion control numbers (effectively overclocking the simulation), it is strongly recommended not to increase the Control Number Factor above the default of 1.0. A hard upper limit has been set to prevent an increase of more than 20% (i.e. Control Number Factor == 1.2). Increasing control numbers by more than this would be likely to lead to instability.
| Up |
|---|
 3xxx Messages
|