Difference between revisions of "TUFLOW Message 2074"
Jump to navigation
Jump to search
Steph.dufour (talk | contribs) |
Steph.dufour (talk | contribs) |
||
| Line 3: | Line 3: | ||
|alt_msg=NA | |alt_msg=NA | ||
|type=[[WARNING]] | |type=[[WARNING]] | ||
| − | |message_desc=SA object does not select any 2D cells (active or inactive). For example this could occur when 2d_sa object is outside the active model area. This warning can also occur if the digitised SA polygon does not select any ZC points as shown in the figure below. | + | |message_desc=SA object does not select any 2D cells (active or inactive). For example this could occur when 2d_sa object is outside the active model area. This warning can also occur if the digitised SA polygon does not select any ZC points as shown in the figure below.<br> |
| + | [[File:WARNING 2074.jpg|600px]] | ||
|suggestions=Check SA object and ensure that it is an active model area and selects at least one ZC zpt, or chose a different inflow location. | |suggestions=Check SA object and ensure that it is an active model area and selects at least one ZC zpt, or chose a different inflow location. | ||
|discussion_page=* [[Talk:TUFLOW Message 2074|Discuss Message 2074]] | |discussion_page=* [[Talk:TUFLOW Message 2074|Discuss Message 2074]] | ||
Revision as of 10:19, 1 October 2014
TUFLOW Message
WARNING 2074 - SA object does not select any 2D cells (active or inactive).
Alternate Message
NA
Message Type
WARNING
Description
SA object does not select any 2D cells (active or inactive). For example this could occur when 2d_sa object is outside the active model area. This warning can also occur if the digitised SA polygon does not select any ZC points as shown in the figure below.
Suggestions
Check SA object and ensure that it is an active model area and selects at least one ZC zpt, or chose a different inflow location.
| Up |
|---|
 2xxx Messages
|