Revision as of 10:03, 2 September 2015 view source Par (talk \| contribs) Bureaucrats, Administrators 1,003 edits No edit summary ← Older edit		Revision as of 10:18, 2 September 2015 view source Par (talk \| contribs) Bureaucrats, Administrators 1,003 edits m Added schematic. Newer edit →
Line 5: \|message_desc=Multiple cross-sections with the same priority have been found for channel. Mid channel cross-sections have higher priority than end cross-sections and will prevail. But if multiple mid channel cross-sections are found TUFLOW will give Error 1123. \|suggestions=Check channel and cross-section configuration, remove unwanted cross-section.<br> If using end cross-sections ensure that the end of the 1d_nwk layer is snapped to a vertex on the cross-section. If this is not the case the cross-section may be treated as a mid cross-section. An example of where this may occur is shown in the schematic below.<br><br> [[File:Error 1123.jpeg\|800px]] \|discussion_page=* [[Talk:TUFLOW Message 1123\|Discuss Message 1123]] \|link3=''

TUFLOW Message 1123: Difference between revisions