TUFLOW Message 1301

TUFLOW Message
ERROR 1301 - No ESTRY nodes found.

Alternate Message
NA

Message Type
ERROR

Description
No 1D nodes have been found.

Suggestions
This error message should only occur for a 1D or 1D/2D model. TUFLOW will check for 1D nodes if:

• An ESTRY control file (.ecf) has been specified; or
• Any 1D commands have been specified in the .tcf.
  

For example the following command in the .tcf will trigger a check for 1D nodes: 1D Output Folder == <output location>
If you are encountering this message for a 2D only model, please remove 1D commands from the control files.

For a model with a 1D component, check that:

• Automatic 1D node creation is turned on and 1D channels have been specified
• If manually specifying 1D nodes, make sure these are being read in correctly.

Up
1xxx Messages