TUFLOW Message 1031

From Tuflow
Revision as of 21:58, 16 March 2016 by Rachel (talk | contribs)
Jump to navigation Jump to search

TUFLOW Message
ERROR 1031 - End of a WLL cannot snap to 1D node

Alternate Message
ERROR 1031 - End of a WLL cannot snap to a 1D channel

Message Type
ERROR

Description
This error indicates that there is a configuration problem with the 1d_wll and 1d_nwk layers

Suggestions
Load the messages, 1d_wll, 1d_nwk and 2d_bc layers into your GIS package. Using the messages layer, locate the area where the error occurs.
Check that the water level lines are configured correctly.

Remember:
Water level lines should go left to right looking downstream.
If the water level lines have only 2 vertices (no nodes on the lines, only a start and an end), then the line must go from 2d_bc to 2d_bc and cross the 1D network.
If the water level line have 3 or more vertices, then the line must go from 2d_bc to 2d_bc and snap to the 1D network.
Should you need further information on configuring water level lines, refer to Tutorial Model 4


Up
Go-up.png 1xxx Messages
Retrieved from "https://wiki.tuflow.com/w/index.php?title=TUFLOW_Message_1031&oldid=9840"