TUFLOW Message 2022
Revision as of 16:21, 6 February 2011 by tuflow>Par
TUFLOW Message
ERROR 2022 - Can only use nearest to line oblique boundary alignment for 2D BC if "Oblique Boundary Method == ON
Alternate Message
NA
Message Type
ERROR
Description
Can only use Oblique Boundary Alignment == NEAREST TO LINE for 2D BC if Oblique Boundary Method == ON.
As of Build 2006-06-AA, this command is considered redundant (other than for backward compatibility), as the Method C or D (Boundary Cell Selection and Line Cell Selection) ensures that the same cells are selected along both HX lines and Z lines.
Suggestions
If using a build of TUFLOW prior to 2006-06-AA and using the Oblique Boundary Alignment == NEAREST TO LINE command, ensure that the Oblique Boundary Method == ON command is also used.
| Up |
|---|
 2xxx Messages
|