EPA SWMM to TUFLOW

Introduction

TUFLOW has supported 1D/2D dynamic coupling since its initial 2D solver development in 1989. Traditionally, 1D linking and associated modeling has been applied using the TUFLOW 1D (ESTRY) solver. New in the 2023-03-AD Release, TUFLOW's 1D linking and solver options have been expanded to support the EPA Storm Water Management Model (referred to herein as SWMM).

As a result of the 1D SWMM inclusion within TUFLOW, modellers working with SWMM files now have a variety of options available:

1. Use SWMM, coupled directly to TUFLOW.
2. Conversion of SWMM 1D geometry to a TUFLOW compatible format for use by TUFLOW 1D (ESTRY) solver.

SWMM inclusion in TUFLOW (2023-03-AD or newer)

If you wish to model SWMM coupled dynamically to TUFLOW 2D, please refer to the TUFLOW SWMM Tutorials. Tutorials are provided for the following topics:

• TUFLOW SWMM Module 1 - 1D SWMM Culverts
• TUFLOW SWMM Module 2 - 1D SWMM Pipe Network / 2D TUFLOW Direct Rainfall Hydrology
• TUFLOW SWMM Module 3 - 1D SWMM Pipe Network / 1D SWMM Urban Hydrology
• TUFLOW SWMM Module 4 - 1D SWMM Pipe Network / 1D SWMM Urban Hydrology: Executing multiple different event simulations from a single model control file.

Conversion of SWMM to TUFLOW 1D (ESTRY)

As an alternative to direct coupling of SWMM with TUFLOW, a free utility tool is also available to assist with the conversion of SWMM inp files into a TUFLOW compatible format for simulation using TUFLOW 1D (ESTRY). The SWMM_to_TUFLOW utility is available for download from the TUFLOW website.

The SWMM_to_TUFLOW utility automates the conversion of SWMM 1D model geometry for culverts, pipes and open channels into a TUFLOW 1D (ESTRY) compatible GIS and tabular format.

Note: TUFLOW 1D does not include an inbuilt hydrology engine. As such, SWMM hydrology and boundary condition information is not processed by this utility. If EPA SWMM hydrology or boundary condition information is important for your model construction, please use direct coupling of EPA SWMM with TUFLOW.

SWMM_to_TUFLOW Utility Execution

1. Save the swmm_to_gis_w64.exe to the same folder as the SWMM file (.inp).
2. The utility requires GIS projection information to correctly translate the spatial information contained in the SWMM file (.inp) to either MapInfo *mif/*mid or ESRI/QGIS *.shp format. This is done by including a Projection file in the working directory. Create one of the following files, saved to the same folder location as the SWMM file (.inp).
   • *mif/*mid format input requirement: Projection.mif
   • *shp format input requirement: Projection.prj

   The following error message will be produced if projection information is not provided:

   ERROR - A Header.prj or Projection.prj file does not exist in folder
   

3. Create a batch (*.bat) in the same folder as the SWMM file (.inp). Depending on the GIS format you desire, use either of the following syntax in the batch file.
   • *mif/*mid format input requirement: swmm_to_GIS.exe -mif SWMM.inp
   • *shp format input requirement: swmm_to_GIS.exe -shp SWMM.inp

   Utility Output

   Example Output