Tutorial M10 004 Results QGIS update V2 draft

Introduction

QGIS is used to view the depth, velocity and water levels with the TUFLOW Viewer 2. For viewing of the 2D map results, see Module 1.

Method

Inspect depth, velocity and water level outputs:

1. Open the Map Outputs results, either:
   • Within the QGIS Browser Panel drag the following layers into the QGIS workspace, or

   • Module_10\TUFLOW\results\M10_5m_004.xmdf > loads the map output mesh results

   • In File Explorer, navigate to the files above and drag and drop them into the QGIS workspace.
2. In the 'Layer' Panel, click on M10_5m_004 and select the 'Depth' and 'Vector Velocity' output type in the 'Datasets' tab.
   
3. Use the Time Series Plot tool to see the time series of the water level at the location downstream of the dambreak hydrograph. The timeseries follows a pattern similar to the inflow hydrograph:
   
   
   
   

Conclusion

• The depth, velocity and water levels were inspected over time using TUFLOW Viewer 2.
• For further functionality, see TUFLOW Viewer 2 documentation.

Up
Back to Module 10 Main Page