Difference between revisions of "TUFLOW Message 0307"
Melissa1987 (talk | contribs) |
Melissa1987 (talk | contribs) |
||
| Line 18: | Line 18: | ||
If a model has a mixture of .mif and .shp files as input, then both the tcf commands <font color="blue"><tt>MI Projection </tt></font> <font color="red"><tt>== </tt></font> and <font color="blue"><tt>SHP Projection </tt></font> <font color="red"><tt>== </tt></font> should be specified. | If a model has a mixture of .mif and .shp files as input, then both the tcf commands <font color="blue"><tt>MI Projection </tt></font> <font color="red"><tt>== </tt></font> and <font color="blue"><tt>SHP Projection </tt></font> <font color="red"><tt>== </tt></font> should be specified. | ||
<br> | <br> | ||
| − | + | ||
|uplink=[[0xxx_TUFLOW_Messages|0xxx Messages]] | |uplink=[[0xxx_TUFLOW_Messages|0xxx Messages]] | ||
| − | |||
}} | }} | ||
Revision as of 11:13, 22 December 2022
TUFLOW Message
WARNING 0307 - No MI Projection or mif header file ",a," found. Non-Earth Coordinates will be used.
Alternate Message
WARNING 0307 - No GIS Projection specified. No output .prj file will be created.
Message Type
WARNING
Description
The geographic projection for GIS input and output data in MID/MIF format has not been defined using the command MI Projection == . When this command is omitted, TUFLOW searches for a file 'Header.mif' in each folder it opens a MID/MIF GIS file and extracts the projection from this file. If no 'Header.mif' file is found, non-earth coordinates are assumed.
Suggestions
Create a projection file by following the instructions outlined on this Wiki page.The created layer then needs to be referenced using the following .tcf command:
MI Projection == ..\model\mi\Model_Projection.mif
Alternatively, a projection line may be extracted from a MIF file by following these steps:
- In a GIS, create or open a layer in the Cartesian projection to be used for the model.
- Export the layer in MIF/MID format.
- Open the .mif file in a text editor, copy the whole line starting with “CoordSys” (usually the 4th or 5th line).
- Paste the text after the command paste after MI Projection == in the .tcf file.
MI Projection == CoordSys Earth Projection 8, 13, "m", 153, 0, 0.9996, 500000, 10000000 Bounds (-7745874.38492, 1999.40969607) (8745874.38492, 19998000.5903)
If a model has a mixture of .mif and .shp files as input, then both the tcf commands MI Projection == and SHP Projection == should be specified.
| Up |
|---|
 0xxx Messages
|