Difference between revisions of "TUFLOW Message 1123"

From Tuflow
Jump to navigation Jump to search
 
(4 intermediate revisions by 3 users not shown)
Line 3: Line 3:
 
|alt_msg=NA
 
|alt_msg=NA
 
|type=[[ERROR]]
 
|type=[[ERROR]]
|message_desc=Multiple cross-sections with the same priority have been found for channel.  Mid channel cross-sections have higher priotity than end cross-sections and will prevail.  But if multiple mid channel cross-sections are found TUFLOW will give Error 1123.
+
|message_desc=Multiple cross-sections with the same priority have been found for channel.  Mid channel cross-sections have higher priority than end cross-sections and will prevail.  But if multiple mid channel cross-sections are found TUFLOW will give Error 1123.
|suggestions=Remove superlative cross-section.
+
|suggestions=Check channel and cross-section configuration, remove unwanted cross-section.<br>
|discussion_page=* [[Talk:TUFLOW Message 1123|Discuss Message 1123]]
+
If using end cross-sections ensure that the end of the 1d_nwk layer is snapped to a vertex on the cross-section.  If this is not the case the cross-section may be treated as a mid cross-section.  An example of where this may occur is shown in the schematic below.<br><br>
|link3=''
+
[[File:Error 1123.jpeg|800px]]
|link4=''
+
 
|prelink=[[TUFLOW_Message_1122|Message 1122]]
 
 
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]]
 
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]]
|nextlink=[[TUFLOW_Message_1124|Message 1124]]
 
 
}}
 
}}

Latest revision as of 15:19, 22 December 2022

TUFLOW Message
ERROR 1123 - More than one cross-section line of same priority for channel

Alternate Message
NA

Message Type
ERROR

Description
Multiple cross-sections with the same priority have been found for channel. Mid channel cross-sections have higher priority than end cross-sections and will prevail. But if multiple mid channel cross-sections are found TUFLOW will give Error 1123.

Suggestions
Check channel and cross-section configuration, remove unwanted cross-section.
If using end cross-sections ensure that the end of the 1d_nwk layer is snapped to a vertex on the cross-section. If this is not the case the cross-section may be treated as a mid cross-section. An example of where this may occur is shown in the schematic below.

Error 1123.jpeg


Up
Go-up.png 1xxx Messages