Difference between revisions of "TUFLOW Message 1151"

From Tuflow
Jump to navigation Jump to search
 
(One intermediate revision by the same user not shown)
Line 5: Line 5:
 
|message_desc=End cross-sections can only be used for "S" or "G" type channels, for other channels please use a mid channel section.
 
|message_desc=End cross-sections can only be used for "S" or "G" type channels, for other channels please use a mid channel section.
 
|suggestions=For channels other the "S" or "G" type channels, use a mid channel section.  A GIS line with only two vertices must intersect or cross the channel line – it does not have to snap to a vertex on the channel line.  If the two-point line crosses more than one channel, the channel that is closest to the mid-point of the line is selected.  Three or more vertex lines must have one of the vertices snap to a vertex on the channel line and are given preference over any two-point line that crosses the channel line.
 
|suggestions=For channels other the "S" or "G" type channels, use a mid channel section.  A GIS line with only two vertices must intersect or cross the channel line – it does not have to snap to a vertex on the channel line.  If the two-point line crosses more than one channel, the channel that is closest to the mid-point of the line is selected.  Three or more vertex lines must have one of the vertices snap to a vertex on the channel line and are given preference over any two-point line that crosses the channel line.
|discussion_page=* [[Talk:TUFLOW Message 1151|Discuss Message 1151]]
+
 
|link3=''
+
 
|link4=''
 
|prelink=[[TUFLOW_Message_1146|Message 1146]]
 
 
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]]
 
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]]
|nextlink=[[TUFLOW_Message_1152|Message 1152]]
 
 
}}
 
}}

Latest revision as of 15:29, 22 December 2022

TUFLOW Message
ERROR 1151 - Channel ",a," must be a G or S channel to use cross-sections at channel ends.

Alternate Message
NA

Message Type
ERROR

Description
End cross-sections can only be used for "S" or "G" type channels, for other channels please use a mid channel section.

Suggestions
For channels other the "S" or "G" type channels, use a mid channel section. A GIS line with only two vertices must intersect or cross the channel line – it does not have to snap to a vertex on the channel line. If the two-point line crosses more than one channel, the channel that is closest to the mid-point of the line is selected. Three or more vertex lines must have one of the vertices snap to a vertex on the channel line and are given preference over any two-point line that crosses the channel line.


Up
Go-up.png 1xxx Messages