Difference between revisions of "TUFLOW Message 1301"

From Tuflow
Jump to navigation Jump to search
(Created page with '{{TUFLOW_Message |tuflow_message=ERROR 1301 - No ESTRY nodes found. |alt_msg=NA |type=ERROR |message_desc=???? |suggestions=???? |discussion_page=* [[Talk:TUFLOW Message 1301...')
 
 
(6 intermediate revisions by 3 users not shown)
Line 3: Line 3:
 
|alt_msg=NA
 
|alt_msg=NA
 
|type=[[ERROR]]
 
|type=[[ERROR]]
|message_desc=????
+
|message_desc=No 1D nodes have been found.
|suggestions=????
+
|suggestions=This error message should only occur for a 1D or 1D/2D model.  TUFLOW will check for 1D nodes if:<br>
|discussion_page=* [[Talk:TUFLOW Message 1301|Discuss Message 1301]]
+
* An ESTRY control file (.ecf) has been specified; or
|link3=''
+
* Any 1D commands have been specified in the .tcf.<br>
|link4=''
+
For example the following command in the .tcf will trigger a check for 1D nodes: <tt><font color="blue">1D Output Folder </font><font color="red">== </font><output location></tt><br>
|prelink=[[TUFLOW_Message_1298|Message 1298]]
+
If you are encountering this message for a 2D only model, please remove 1D commands from the control files.<br>
 +
<br>
 +
For a model with a 1D component, check that:<br>
 +
* Automatic 1D node creation is turned on and 1D channels have been specified
 +
* If manually specifying 1D nodes, make sure these are being read in correctly.
 +
 
 
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]]
 
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]]
|nextlink=[[TUFLOW_Message_1302|Message 1302]]
 
 
}}
 
}}

Latest revision as of 10:25, 23 December 2022

TUFLOW Message
ERROR 1301 - No ESTRY nodes found.

Alternate Message
NA

Message Type
ERROR

Description
No 1D nodes have been found.

Suggestions
This error message should only occur for a 1D or 1D/2D model. TUFLOW will check for 1D nodes if:

  • An ESTRY control file (.ecf) has been specified; or
  • Any 1D commands have been specified in the .tcf.

For example the following command in the .tcf will trigger a check for 1D nodes: 1D Output Folder == <output location>
If you are encountering this message for a 2D only model, please remove 1D commands from the control files.

For a model with a 1D component, check that:

  • Automatic 1D node creation is turned on and 1D channels have been specified
  • If manually specifying 1D nodes, make sure these are being read in correctly.


Up
Go-up.png 1xxx Messages