Difference between revisions of "TUFLOW Message 1301"
Jump to navigation
Jump to search
m |
Melissa1987 (talk | contribs) |
||
| (4 intermediate revisions by 2 users not shown) | |||
| Line 4: | Line 4: | ||
|type=[[ERROR]] | |type=[[ERROR]] | ||
|message_desc=No 1D nodes have been found. | |message_desc=No 1D nodes have been found. | ||
| − | |suggestions= | + | |suggestions=This error message should only occur for a 1D or 1D/2D model. TUFLOW will check for 1D nodes if:<br> |
| − | + | * An ESTRY control file (.ecf) has been specified; or | |
| − | + | * Any 1D commands have been specified in the .tcf.<br> | |
| − | + | For example the following command in the .tcf will trigger a check for 1D nodes: <tt><font color="blue">1D Output Folder </font><font color="red">== </font><output location></tt><br> | |
| − | + | If you are encountering this message for a 2D only model, please remove 1D commands from the control files.<br> | |
| + | <br> | ||
| + | For a model with a 1D component, check that:<br> | ||
| + | * Automatic 1D node creation is turned on and 1D channels have been specified | ||
| + | * If manually specifying 1D nodes, make sure these are being read in correctly. | ||
| + | |||
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]] | |uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]] | ||
| − | |||
}} | }} | ||
Latest revision as of 10:25, 23 December 2022
TUFLOW Message
ERROR 1301 - No ESTRY nodes found.
Alternate Message
NA
Message Type
ERROR
Description
No 1D nodes have been found.
Suggestions
This error message should only occur for a 1D or 1D/2D model. TUFLOW will check for 1D nodes if:
- An ESTRY control file (.ecf) has been specified; or
- Any 1D commands have been specified in the .tcf.
For example the following command in the .tcf will trigger a check for 1D nodes: 1D Output Folder == <output location>
If you are encountering this message for a 2D only model, please remove 1D commands from the control files.
For a model with a 1D component, check that:
- Automatic 1D node creation is turned on and 1D channels have been specified
- If manually specifying 1D nodes, make sure these are being read in correctly.
| Up |
|---|
 1xxx Messages
|