Difference between revisions of "TUFLOW Message 2075"
Melissa1987 (talk | contribs) |
|||
| (3 intermediate revisions by the same user not shown) | |||
| Line 6: | Line 6: | ||
<br> | <br> | ||
The geometry control file (.tgc) file command:<br> | The geometry control file (.tgc) file command:<br> | ||
| − | <font color=" | + | <font color="blue"><tt>Allow Dangling Z Lines </tt></font><font color="red"><tt>== </tt></font><font color="black"><tt>ON</tt></font><br> |
| − | Can be added, in this case TUFLOW assigns the elevation of the nearest snapped point to the dangling end. This command may be used several times through a .tgc file to change the setting before different <font color=" | + | Can be added, in this case TUFLOW assigns the elevation of the nearest snapped point to the dangling end. This command may be used several times through a .tgc file to change the setting before different <font color="blue"><tt>Read GIS Z Line </tt></font><font color="red"><tt>== </tt></font> commands. Elevations applied to dangling ends are displayed to the screen and log file. |
| − | |suggestions=Add an elevation point to the end of the breakline or add the <font color=" | + | |suggestions=Add an elevation point to the end of the breakline or add the <font color="blue"><tt>Allow Dangling Z Lines </tt></font><font color="red"><tt>== </tt></font><font color="black"><tt>ON</tt></font>. |
| − | + | ||
| − | + | ||
| − | |||
| − | |||
|uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] | |uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] | ||
| − | |||
}} | }} | ||
Latest revision as of 11:57, 23 December 2022
TUFLOW Message
WARNING 2075 - 3D breakline with snapped point(s) does not have a point at its start. 2D line assumed.
Alternate Message
NA
Message Type
WARNING
Description
3D breakline with snapped point(s) does not have a point at its start. The line is assumed to be a 2D break line (ie. a line of constant height). If using a breakline with elevaton points snapped anywhere along its length it should have points and the start and end of the line. In this case the elevation of the line oject is used.
The geometry control file (.tgc) file command:
Allow Dangling Z Lines == ON
Can be added, in this case TUFLOW assigns the elevation of the nearest snapped point to the dangling end. This command may be used several times through a .tgc file to change the setting before different Read GIS Z Line == commands. Elevations applied to dangling ends are displayed to the screen and log file.
Suggestions
Add an elevation point to the end of the breakline or add the Allow Dangling Z Lines == ON.
| Up |
|---|
 2xxx Messages
|