Difference between revisions of "TUFLOW Message 2839"

From Tuflow
Jump to navigation Jump to search
Line 4: Line 4:
 
|type=[[ERROR]]
 
|type=[[ERROR]]
 
|message_desc=This error can occur for any line features, for example when PO lines or part of PO lines are outside the model area for Quadtree models.
 
|message_desc=This error can occur for any line features, for example when PO lines or part of PO lines are outside the model area for Quadtree models.
|suggestions=Inspect line feature associated with the error message. Check that all PO lines are located within the model area, or contact [mailto:support@tuflow.com support@tuflow.com] for more help.
+
|suggestions=Inspect line feature associated with the error message. Check that all PO lines are located within the model area, or contact <u>[mailto:support@tuflow.com support@tuflow.com]</u> for more help.
 
|discussion_page=* [[Talk:TUFLOW Message 2839|Discuss Message 2839]]
 
|discussion_page=* [[Talk:TUFLOW Message 2839|Discuss Message 2839]]
 
|link3=''
 
|link3=''

Revision as of 10:59, 4 July 2022

TUFLOW Message
ERROR 2839 - Unable to split polyline according to QPC mesh

Alternate Message
ERROR 2839 - Split polyline should not have more vertexes than the original polyline

Message Type
ERROR

Description
This error can occur for any line features, for example when PO lines or part of PO lines are outside the model area for Quadtree models.

Suggestions
Inspect line feature associated with the error message. Check that all PO lines are located within the model area, or contact support@tuflow.com for more help.


Up
Go-up.png 2xxx Messages