Difference between revisions of "TUFLOW Message 2839"

From Tuflow
Jump to navigation Jump to search
Line 6: Line 6:
 
|suggestions=Inspect line feature associated with the error message. Check that all PO lines are located within the model area, or contact <u>[mailto:support@tuflow.com support@tuflow.com]</u> for more help.
 
|suggestions=Inspect line feature associated with the error message. Check that all PO lines are located within the model area, or contact <u>[mailto:support@tuflow.com support@tuflow.com]</u> for more help.
  
|prelink=[[TUFLOW_Message_2836|Message 2836]]
+
|prelink=[[TUFLOW_Message_2838|Message 2838]]
 
|uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]]
 
|uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]]
|nextlink=[[TUFLOW_Message_2843|Message 2843]]
+
|nextlink=[[TUFLOW_Message_2840|Message 2840]]
 
}}
 
}}

Revision as of 12:38, 16 December 2022

TUFLOW Message
ERROR 2839 - Unable to split polyline according to QPC mesh

Alternate Message
ERROR 2839 - Split polyline should not have more vertexes than the original polyline

Message Type
ERROR

Description
This error can occur for any line features, for example when PO lines or part of PO lines are outside the model area for Quadtree models.

Suggestions
Inspect line feature associated with the error message. Check that all PO lines are located within the model area, or contact support@tuflow.com for more help.


Up
Go-up.png 2xxx Messages