TUFLOW Message 2839

From Tuflow
Revision as of 09:59, 23 September 2020 by ShuangGao (talk | contribs)
Jump to navigation Jump to search

TUFLOW Message
ERROR 2839 - Unable to split polyline according to QPC mesh

Alternate Message
ERROR 2839 - Split polyline should not have more vertexes than the original polyline

Message Type
ERROR

Description
This error can occur when PO lines or part of PO lines are outside the model area for Quadtree models.

Suggestions
Check that all PO lines are located within the model area, or contact support@tuflow.com for more support.


Up
Go-up.png 2xxx Messages