Difference between revisions of "TUFLOW Message 3008"

From Tuflow
Jump to navigation Jump to search
Line 13: Line 13:
 
<br>
 
<br>
 
where ''Cc (nut_c)'' is a constant component of the viscosity, and the maximum value of ''l'' is limited by ''Cm * depth'', where ''Cm (nut_m)'' is a coefficient to define the turbulence length scale.
 
where ''Cc (nut_c)'' is a constant component of the viscosity, and the maximum value of ''l'' is limited by ''Cm * depth'', where ''Cm (nut_m)'' is a coefficient to define the turbulence length scale.
|suggestions=Make sure the parameters specified by the <font color="blue"><tt>Viscosity Coefficients </tt></font> <font color="red"><tt>== </tt></font> command is larger than zero.  
+
|suggestions=Ensure that the parameters specified by the <font color="blue"><tt>Viscosity Coefficients </tt></font> <font color="red"><tt>== </tt></font> command are larger than zero.  
  
 
|discussion_page=* [[Talk:TUFLOW Message 3008|Discuss Message 3008]]
 
|discussion_page=* [[Talk:TUFLOW Message 3008|Discuss Message 3008]]

Revision as of 16:03, 16 July 2018

TUFLOW Message
ERROR 3008: nut_m must be >= 0.
ERROR 3008: nut_c must be >= 0

Alternate Message


Message Type
ERROR

Description
SMAGORINSKY turbulence model:
When SMAGORINSKY turbulence model is used, nut_m is the Smagorinsky coefficient and nut_c is a constant eddy viscosity component. These two parameter must be >=0.

PRANDTL turbulence model:
If the PRANDTL turbulence model is selected, the viscosity is modelled based on the turbulence length scale l and the turbulence intensity k as follows:
PRANDTL.png
where Cc (nut_c) is a constant component of the viscosity, and the maximum value of l is limited by Cm * depth, where Cm (nut_m) is a coefficient to define the turbulence length scale.

Suggestions
Ensure that the parameters specified by the Viscosity Coefficients == command are larger than zero.


Up
Go-up.png 3xxx Messages