Difference between revisions of "TUFLOW Message 3991"

From Tuflow
Jump to navigation Jump to search
Line 19: Line 19:
 
|link3=''
 
|link3=''
 
|link4=''
 
|link4=''
|prelink=[[TUFLOW_Message_3048|Message 3048]]
+
|prelink=[[TUFLOW_Message_3506|Message 3506]]
 
|uplink=[[3xxx_TUFLOW_Messages|3xxx Messages]]
 
|uplink=[[3xxx_TUFLOW_Messages|3xxx Messages]]
 
|nextlink=[[TUFLOW_Message_3999|Message 3999]]
 
|nextlink=[[TUFLOW_Message_3999|Message 3999]]
 
}}
 
}}

Revision as of 16:39, 28 February 2020

TUFLOW Message
WARNING 3991: Negative depth at "a".

Alternate Message
N/A

Message Type
WARNING

Description
Numerical solution has resulted in a negative depth at specified location. This indicates that the model is unstable or unhealthy in this area.

Suggestions
Import the messages layer in to your GIS package. Check for the number and time at which these warnings occur. A few warnings at a single location or timestep in the simulation are not normally an issue. Persistent warnings however warrant further investigation. Check the following:

  • Depth discharge curve for Q pits;
  • Incorrect bed levels upstream or downstream;
  • A large change in cross-sectional area;
  • Very steep channel entering a gently or adverse grade channel;
  • Sudden change in flow area (for example a culvert width entered in mm not m, 1200mm rather than 1.2m);
  • Issues with 1D/2D linking (incorrect use of Z flag on culvert inlet / outlet);
  • Too high a timestep; and
  • Too small a nodal area.


Up
Go-up.png 3xxx Messages