Difference between revisions of "TUFLOW Message 2830"
| (3 intermediate revisions by 3 users not shown) | |||
| Line 3: | Line 3: | ||
|alt_msg=ERROR 2830 - Nesting polygon outside computational domain. | |alt_msg=ERROR 2830 - Nesting polygon outside computational domain. | ||
|type=[[ERROR]] | |type=[[ERROR]] | ||
| − | |message_desc=Quadtree nesting polygons can only be within | + | |message_desc=Quadtree nesting polygons can only be completely within level 1 polygon in 2d_qnl layer or 2d_code layer if level 1 polygon in 2d_qnl layer is not used.<br> |
Quadtree nesting polygons can only be within the model domain. | Quadtree nesting polygons can only be within the model domain. | ||
| − | |suggestions=Check the extent of nesting polygons is within | + | |suggestions=Check the extent of nesting polygons is completely within level 1 polygon in 2d_qnl layer or 2d_code layer if level 1 polygon in 2d_qnl layer is not used. If "Model Origin and Extent" and "Orientation Angle" is set to "TGC" level 1 polygon doesn't need to be specified. In such case model domain will be used as level 1 polygon and nesting levels can be snapped to the code polygon.<br> |
Check the dom_check file if it needs extending. If TUFLOW doesn't produce this file, insert "Verbose == ON" in .tcf to output pre-processing dom_check file. | Check the dom_check file if it needs extending. If TUFLOW doesn't produce this file, insert "Verbose == ON" in .tcf to output pre-processing dom_check file. | ||
| − | + | ||
| − | |||
| − | |||
| − | |||
|uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] | |uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] | ||
| − | |||
}} | }} | ||
Latest revision as of 10:02, 3 March 2023
TUFLOW Message
ERROR 2830 - Nesting polygon outside level 1 polygon.
Alternate Message
ERROR 2830 - Nesting polygon outside computational domain.
Message Type
ERROR
Description
Quadtree nesting polygons can only be completely within level 1 polygon in 2d_qnl layer or 2d_code layer if level 1 polygon in 2d_qnl layer is not used.
Quadtree nesting polygons can only be within the model domain.
Suggestions
Check the extent of nesting polygons is completely within level 1 polygon in 2d_qnl layer or 2d_code layer if level 1 polygon in 2d_qnl layer is not used. If "Model Origin and Extent" and "Orientation Angle" is set to "TGC" level 1 polygon doesn't need to be specified. In such case model domain will be used as level 1 polygon and nesting levels can be snapped to the code polygon.
Check the dom_check file if it needs extending. If TUFLOW doesn't produce this file, insert "Verbose == ON" in .tcf to output pre-processing dom_check file.
| Up |
|---|
 2xxx Messages
|