Tutorial M10 001 Results QGIS: Difference between revisions
Content deleted Content added
Created page with "=Introduction= QGIS is used to view the bathymetry and water depth with the TUFLOW Viewer. For viewing of the 2D map results, see <u> Module 1</..." |
No edit summary |
||
| (One intermediate revision by the same user not shown) | |||
Line 11:
<li>Use the Cross Section tool to plot the bathymetry and bed elevation (elevation at the beginning of the simulation) at the location of the dam break. The dam break begins at 1 hour and takes 15 minutes to fully develop:<br>
<br>
{{Video|name=Animation_M10_001_Results_01d.mp4|width=1238}}<br>
<br>
<li>Use the Plot Time Series tool to see the time series of the bathymetry and water level at the location of the dam break, whilst viewing the depth result type. Due to the IWL, water is within the dam at the beginning of the simulation <br>
<br>
{{Video|name=Animation_M10_001_Results_02a.mp4|width=1238}}<br>
<br>
</ol><br>
Line 21:
=Conclusion=
:*A cross section of the dam wall was inspected showing the bathymetry changing over time.
:*Time series of bathymetry and water level were inspected at the location of the dam break.
:*For further functionality, see <u>[[TUFLOW_Viewer | TUFLOW Viewer]]</u>.<br>
<br>
| |||