Revision as of 20:02, 24 October 2016

Introduction

This page describes the method of creating TUFLOW GIS based layers to reference the nodes within the Flood Modeller model

Open the FloodModeller_Nodes. GIS layer from Module_Data\Module_01\gis folder.
Save as 1d_x1d_FMT_M01_nodes_001.shp within the TUFLOW\model\gis folder.
Open the GIS layer 1d_x1d_FMT_M01_nodes_001.shp_p within QGIS.
Interrogate one of the digitised points and inspect the attributes. Note that each point has a unique name which correlates to a RIVER, INTERPOLATE or REPLICATE unit within the Flood Modeller model. At junctions, both the upstream and downstream nodes must be digitised within this layer.

Save the file in preparation for reading into TUFLOW.

The node IDs are case-sensitive as this is a requirement of Flood Modeller

Please return to the Flood Modeller Tutorial Model module 1 page here.

@@ Line 9: / Line 9: @@
 <li> Open the GIS layer 1d_x1d_FMT_M01_nodes_001.shp_p within QGIS.</li>
 <li> Interrogate one of the digitised points and inspect the attributes. Note that each point has a unique name which correlates to a RIVER, INTERPOLATE or REPLICATE unit within the Flood Modeller model. At junctions, both the upstream and downstream nodes must be digitised within this layer.</li>
-<li> Save the file in preparation for reading into TUFLOW.
 [[File:FMT_QGISx1D_Nodes.JPG|600px]]
+<li> Save the file in preparation for reading into TUFLOW.
 {| align="center" class="wikitable"