Revision as of 21:07, 13 July 2023

Introduction

QGIS is used to load and view a range of event magnitudes and durations with the TUFLOW Viewer. For viewing of the 2D map results, see Module 1.

Set the QGIS workspace projection to EPSG:32760, see Set the Projection.

Save the QGIS workspace by selecting Project > Save As.

Inspect the results for all events:

Open the TUFLOW Viewer.
Load the results using the TCF. From File > Load Results, navigate to the Module_09\TUFLOW\runs folder and select the following file:
- M09_5m_~e1~_~e2~_001.tcf
When prompted, click 'Select All' and 'Ok'. The TUFLOW Viewer opens all six simulation runs using event management:
Inspect the extent, water level and the flow plot output for each event:

The results of all event magnitudes and durations were inspected using the TUFLOW Viewer.
For further functionality, see TUFLOW Viewer.

Up
Back to Module 9 Main Page

@@ Line 4: / Line 4: @@
 = TUFLOW Project Re-Configuration =
-Re-configure the TUFLOW project to use and save empty files to the correct folder:<br>
-<ol>
-<li>Go to Plugins > TUFLOW > Editing > Configure / Create TUFLOW Project.
-<li>Change the folder which contains TUFLOW to the '''Module_09''' folder. This is the only change required, the model folder structure and template empty files are supplied from previous model.<br>
-Note: The 'results' and 'check' folder get automatically created when the TUFLOW model is run. <br>
-<li>Click 'OK' and save the QGIS workspace by selecting Project > Save As.<br>
-<br>
-[[File:M09_SHP_ConfigureProject.PNG]]<br><br>
 <li>Set the QGIS workspace projection to EPSG:32760, see <u>[https://wiki.tuflow.com/index.php?title=Tutorial_Site_Familiarisation_QGIS#Set_the_Projection Set the Projection]</u>.
+<li>Save the QGIS workspace by selecting Project > Save As.<br>
 </ol>
 <br>