TUFLOW CATCH Tutorial M01 Results QGIS: Difference between revisions
Content deleted Content added
No edit summary |
|||
Line 42:
</ol>
== TUFLOW HPC
Review the TUFLOW HPC Map outputs with TUFLOW Viewer:
<ol>
<li> Load the '''2d_mat_TC01_001.shp''' layer from the '''Modelling\TUFLOW\model\gis''' folder into QGIS.
<li>Open TUFLOW Viewer from the TUFLOW Plugin toolbar.<br>
<br>
[[File:tuflow_plugin_tuflow_viewer.png]]<br>
<br>
<li>Open the simulation results. Select File > Load Results - Map Outputs. Navigate to the '''Modelling\TUFLOWCatch\results''' folder and select '''TC01_001_catchment_hydraulic.xmdf'''.
<li>In the TUFLOW Viewer panel, select 'Conc SED_CLAY' from the Result Type list. As the output concentrations often vary significantly, making them difficult to interpret, it is recommended to adjust the symbology as shown in the video below. A smaller concentration range will enhance the visibility of finer differences in the outputs.
<br>
{{Video|name=}}<br>
<li>Review the pollutant concentrations of clay and ecoli throughout the model simulation. Notice how the water flows over the different material regions.
<br>
{{Video|name=}}<br>
<li>Zoom in to the downstream end of the model. Use the Plot Time Series tool to see the pollutant concentrations at various locations around the receiving polygon. These time series concentrations should be similar to the '''TC01_001_catchment_hydraulic_receiving.csv''' output.
<br>
{{Video|name=}}<br>
<li>Select 'Dry Mass WQ_PATH_ECOLI_ALIVE_CFU_100ML' from the result type list. This is the dry mass of the accumulated alive ecoli. Notice that at the start of the simulation, there is no dry mass, but as the model continues, the dry mass accumulates on the paddocks, and then runs off.
<br>
{{Video|name=}}<br>
</ol>
<br>
| |||