Tutorial M09 Results QGIS

Introduction

QGIS is used to load and view a range of event magnitudes and durations with the TUFLOW Viewer. For viewing of the 2D map results, see Module 1.

TUFLOW Project Re-Configuration

Re-configure the TUFLOW project to use and save empty files to the correct folder:

1. Go to Plugins > TUFLOW > Editing > Configure / Create TUFLOW Project.
2. Change the folder which contains TUFLOW to the Module_09 folder. This is the only change required, the model folder structure and template empty files are supplied from previous model.
   Note: The 'results' and 'check' folder get automatically created when the TUFLOW model is run.
   
3. Click 'OK' and save the QGIS workspace by selecting Project > Save As.
   
   
   
   
4. Set the QGIS workspace projection to EPSG:32760, see Set the Projection.

Method

Inspect the results for all events:

1. Open the TUFLOW Viewer.
2. Load the results using the TCF. From File > Load Results, navigate to the Module_09\TUFLOW\runs folder and select the following file:

   • M09_5m_~e1~_~e2~_001.tcf

3. When prompted, click 'Select All' and 'Ok'. The TUFLOW Viewer opens all six simulation runs using event management:
   
   
   
   
4. Inspect the extent, water level and the flow plot output for each event:
   
   
   
   

Conclusion

• The results of all event magnitudes and durations were inspected using the TUFLOW Viewer.
• For further functionality, see TUFLOW Viewer.
  

Up
Back to Module 9 Main Page