Tutorial M09 Results QGIS update V2 draft

Introduction

QGIS is used to load and view a range of event magnitudes and durations with the TUFLOW Viewer 2. For viewing of the 2D map results, see Module 1.

TUFLOW Project Re-Configuration

1. Set the QGIS workspace projection to EPSG:32760, see Set the Projection.
2. Save the QGIS workspace by selecting Project > Save As.
   

Method

Inspect the results for all events:

1. Open the Map Outputs and Time Series results, either:
   • Within the QGIS Browser Panel drag the following layers into the QGIS workspace, or

   • Module_09\TUFLOW\results\M09_5m_05p_1hr_001.xmdf > loads the 1% 1hr map output mesh results
   • Module_09\TUFLOW\results\M09_5m_05p_2hr_001.xmdf > loads the 1% 2hr map 1hr output mesh results
   • Module_09\TUFLOW\results\M09_5m_02p_1hr_001.xmdf > loads the 2% 1hr map output mesh results
   • Module_09\TUFLOW\results\M09_5m_02p_2hr_001.xmdf > loads the 2% 2hr map output mesh results
   • Module_09\TUFLOW\results\M09_5m_01p_1hr_001.xmdf > loads the 5% 1hr map output mesh results
   • Module_09\TUFLOW\results\M09_5m_01p_2hr_001.xmdf > loads the 5% 2hrmap output mesh results
   • Module_09\TUFLOW\results\plot\M09_5m_01p_1hr_001 > loads the time series output results for the 1% 1hr simulation
   • Module_09\TUFLOW\results\plot\M09_5m_01p_2hr_001 > loads the time series output results for the 1% 2hr simulation

2. The TUFLOW Viewer displays all six simulation runs using event management:
   
   
   
   

   
   

3. Inspect the extent, water level and the flow plot output for each event:
   
   
   
   

   
   

Conclusion

• The results of all event magnitudes and durations were inspected using the TUFLOW Viewer.
• For further functionality, see TUFLOW Viewer 2 documentation.

Up
Back to Module 9 Main Page