TUFLOW Message 1262
Revision as of 09:33, 2 February 2011 by tuflow>Par
TUFLOW Message
WARNING 1262 - Manning's n value of ",a," for channel ",a," is unusually low or high.
Alternate Message
NA
Message Type
WARNING
Description
Manning's n value assigned to channel is outside normal range.
Suggestions
Check Manning's n value for channel. If material values are defined in the XZ cross-section ("M" flag), the n_or_n_F attribute in the 1d_nwk is a multiplication factor and should be set to 1 (this may be adjusted as part of the calibration process). This can occur if a the multiplication value is set to a typical Manning's value (e.g. 0.04) and materials are defined in the XZM cross-section. In this case the Manning's n value may become 0.04 x 0.04 = 0.0016!
| Up |
|---|
 1xxx Messages
|