QGIS SWMM Junctions Downstream Junctions to Outfalls
Introduction
This tool converts junctions on the downstream side of a network to outfall nodes as required by SWMM. An outfall layer with the converted nodes will be created along with a modified junction layer (outfall nodes removed). The contents of these layers needs to be copied into the appropriate layers in the SWMM GeoPackage.
Note: This tool relies on the 'From Node' and 'To Node' fields to determine position in the network. The Conduits - Assign node fields processing tool will ensure the 'From Node' and 'To Node' fields are correctly assigned.
Usage
This tool, Junctions - Downstream junctions to outfalls, can be found in the QGIS processing toolbox panel under TUFLOW >> SWMM. To open the Processing Toolbox panel, navigate to 'Processing' in the menubar and select 'Toolbox'.
Parameters
- Input junctions: The existing junctions layer to be converted.
- Selected features only: If nodes(s) in the junctions layer have been selected using the 'Select Features' tool, this option will become available. If this is checked on, the tool will only convert the nodes that have been selected.
- Input conduits: The conduits layer to which the junctions and outfalls are connected.
- Modified junctions layer: Determines the location and filename of the modified junctions layer (outfall nodes removed).
- New outfalls layer: Determines the location and filename of the new outfalls layer.
Example
| Up |
|---|
 Back to TUFLOW QGIS Plugin Main Page
|