TUFLOW Message 2810
Revision as of 10:28, 21 October 2024 by Emilie Nielsen (talk | contribs)
TUFLOW Message
CHECK 2810 - No "Base Cell Size" command specified in .qcf using cell size in .tgc.
Alternate Message
CHECK 2810 - No "Orientation Angle" command specified in .qcf using angle in .tgc.
Message Type
CHECK
Description
The Quadtree Control File (QCF) command Base Cell Size == and/or the QCF command Orientation Angle == were not implemented, so the cell size and/or the orientation angle will default to the values assigned in the TGC.
Suggestions
If required, include the Base Cell Size == and/or the Orientation Angle == command in the QCF.
Refer to the TUFLOW Manual for more information on the available QCF commands.
Up |
---|
2xxx Messages |