Check Files 2d vzsh

This GIS check file layer is only written if a variable Z shape object (2d_vzsh) is used in the model. vzsh_zpt_check contains information on the elevation points that may change over time, the elevation change, final elevation as well as the trigger conditions.
Note that if using a variable Z shape, the map output type "zh" can be included in the Map Output Data Type == command to write the elevations over time. For example, the following command would output water levels (h), velocities (v), depths (d) and elevations (zh):
Map Output Data Type == h v d zh

Attributes of vzsh_zpt_check

Attribute Name	Attribute Description
dZ	The change in elevation that will be caused by the variable Z shape. A negative value indicates the elevation will decrease and a positive value indicates the elevation will increase.
Final_Z	The final elevation after variable elevation has been triggered.
Type	Whether the variable Z shape is applying as a point or side.
Period	The number of hours over which the elevation change will occur.
When	A text description of when the change will start. For example "Water level at [138;76] exceeds 41.".
Reinstate	A text description of when the elevation reinstate option used. "Not Set" if no reinstate occurs. For example: Starting <value>hours afterwards over a period of <value> hours, once only.
Time_Intrp
Source	The input GIS file which was used.

In the image below, the _vzsh_zpt_check has been styled by the dZ attribute (default TUFLOW styling).

Up
TUFLOW Check Files