QGIS SWMM BC Create Channel Endpoint 1D/2D Connections

From Tuflow
Jump to navigation Jump to search

Introduction

This tool creates 1D/2D connections at the endpoints of SWMM channels. HX connections are created on the upstream end and SX connections are created on the downstream end.
Note: The positions of the HX and SX connections may not be completely accurate, so it is recommended for the user to check the output.

Usage

This tool, BC - Create channel endpoint 1D/2D connections, can be found in the QGIS processing toolbox panel under TUFLOW >> SWMM. To open the Processing Toolbox panel, navigate to 'Processing' in the menubar and select 'Toolbox'.

Open processing toolbox.png

Parameters

  1. Input Conduits Layer: The conduits layer to which the 1D/2D connections will be made. To only create connections for some of the conduits, select the desired ones and tick on 'Selected features only'.
  2. Selected features only: If channel(s) in the conduits layer have been selected using the 'Select Features' tool, this option will become available. If this is checked on, the tool will only create 1D/2D connections for the channels that have been selected.
  3. Create connections at: Specifies whether the 1D/2D connections are made at the upstream end, downstream end or both ends of the conduits.
  4. Offset distance: Distance from the channel endpoint to the midpoint of the BC line.
  5. Length of BC lines: Length of BC lines.
  6. Set 2D cell elevation to 1D culvert invert at 1D/2D connection cells if needed: If this is checked on, SX and HX boundaries will have the 'Flags' attribute set to 'Z'. This ensures that the valid elevations occur at the 1D/2D interface. HX boundaries require 2D cell elevations at or above the 1D elevation while SX boundaries require 2D cell elevations at or below the 1D elevation.
  7. Output Layer: Determines the location and filename of the output file. It is recommended to name the output layer with the prefix 2d_bc so TUFLOW styles can be automatically applied.


BC Create Channel Endpoint 1D2D Connections Dialog a.png

Example


Up
Go-up.png Back to TUFLOW QGIS Plugin Main Page