Difference between revisions of "TUFLOW Message 1262"
Jump to navigation
Jump to search
Melissa1987 (talk | contribs) |
|||
| (3 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
{{TUFLOW_Message | {{TUFLOW_Message | ||
| − | |tuflow_message=WARNING 1262 - Manning's n value of | + | |tuflow_message=WARNING 1262 - Manning's n value of <Manning's n value> for channel <Channel ID> is unusually low or high. |
|alt_msg=NA | |alt_msg=NA | ||
|type=[[WARNING]] | |type=[[WARNING]] | ||
|message_desc=Manning's n value assigned to channel is outside normal range. | |message_desc=Manning's n value assigned to channel is outside normal range. | ||
|suggestions=Check Manning's n value for channel. If material values are defined in the XZ cross-section ("M" flag), the n_or_n_F attribute in the 1d_nwk is a multiplication factor and should be set to 1 (this may be adjusted as part of the calibration process). This can occur if a the multiplication value is set to a typical Manning's value (e.g. 0.04) and materials are defined in the XZM cross-section. In this case the Manning's n value may become 0.04 x 0.04 = 0.0016! | |suggestions=Check Manning's n value for channel. If material values are defined in the XZ cross-section ("M" flag), the n_or_n_F attribute in the 1d_nwk is a multiplication factor and should be set to 1 (this may be adjusted as part of the calibration process). This can occur if a the multiplication value is set to a typical Manning's value (e.g. 0.04) and materials are defined in the XZM cross-section. In this case the Manning's n value may become 0.04 x 0.04 = 0.0016! | ||
| − | + | ||
| − | + | ||
| − | |||
| − | |||
|uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]] | |uplink=[[1xxx_TUFLOW_Messages|1xxx Messages]] | ||
| − | |||
}} | }} | ||
Latest revision as of 16:00, 22 December 2022
TUFLOW Message
WARNING 1262 - Manning's n value of <Manning's n value> for channel <Channel ID> is unusually low or high.
Alternate Message
NA
Message Type
WARNING
Description
Manning's n value assigned to channel is outside normal range.
Suggestions
Check Manning's n value for channel. If material values are defined in the XZ cross-section ("M" flag), the n_or_n_F attribute in the 1d_nwk is a multiplication factor and should be set to 1 (this may be adjusted as part of the calibration process). This can occur if a the multiplication value is set to a typical Manning's value (e.g. 0.04) and materials are defined in the XZM cross-section. In this case the Manning's n value may become 0.04 x 0.04 = 0.0016!
| Up |
|---|
 1xxx Messages
|