Difference between revisions of "TUFLOW Message 1278"

From Tuflow
Jump to navigation Jump to search
Line 6: Line 6:
 
|type=[[ERROR]] <br> [[WARNING]]
 
|type=[[ERROR]] <br> [[WARNING]]
 
|message_desc=The inlet level for the pit below the lowest connect channel / culvert.
 
|message_desc=The inlet level for the pit below the lowest connect channel / culvert.
|suggestions=Check inputs and ensure that invert levels are being correctly specified.
+
|suggestions=Check inputs and ensure that invert levels are being correctly specified.<br><br>
 +
'''SGS model''': Users may receive this error after converting a working non-SGS model to an SGS model. In a non-SGS model, the cell elevations are sampled at the cell centres, while an SGS model samples DEM elevations inside the cells based on the SGS sample distance and use the lowest elevations inside the cell as the “pit inlet level”. Therefore, the SGS model might picked up an elevation lower than the pipe invert level. In such case, the "US_Invert" attribute of the 1d_nwk GIS layer can be used to manually specify the ground elevation of the pit. "SXL" option is normally not necessary in an SGS model if the DEM resolution is fine enough
 +
If possible, it is suggested to review the cell size of the model, so that the model doesn't sample an elevation too far away from the pit. Alternatively,
 
|discussion_page=* [[Talk:TUFLOW Message 1278|Discuss Message 1278]]
 
|discussion_page=* [[Talk:TUFLOW Message 1278|Discuss Message 1278]]
 
|link3=''
 
|link3=''

Revision as of 11:44, 23 November 2020

TUFLOW Message
ERROR 1278 - Pit <pit ID> inlet level is below lowest channel/pipe bed.
Pit Entry Level = <value> Lowest Channel/Pipe Invert = <value>

Alternate Message
WARNING 1278 - Pit <pit ID> inlet level is below lowest channel/pipe bed.

Message Type
ERROR
WARNING

Description
The inlet level for the pit below the lowest connect channel / culvert.

Suggestions
Check inputs and ensure that invert levels are being correctly specified.

SGS model: Users may receive this error after converting a working non-SGS model to an SGS model. In a non-SGS model, the cell elevations are sampled at the cell centres, while an SGS model samples DEM elevations inside the cells based on the SGS sample distance and use the lowest elevations inside the cell as the “pit inlet level”. Therefore, the SGS model might picked up an elevation lower than the pipe invert level. In such case, the "US_Invert" attribute of the 1d_nwk GIS layer can be used to manually specify the ground elevation of the pit. "SXL" option is normally not necessary in an SGS model if the DEM resolution is fine enough If possible, it is suggested to review the cell size of the model, so that the model doesn't sample an elevation too far away from the pit. Alternatively,


Up
Go-up.png 1xxx Messages