Difference between revisions of "TUFLOW Message 2340"
(Created page with "{{TUFLOW_Message |tuflow_message=ERROR 2340 - Less than 8 attributes for 2d_bc file: <filename> |alt_msg=NA |type=ERROR |message_desc=The file being read into the 2D model...") |
|||
| Line 10: | Line 10: | ||
|link3='' | |link3='' | ||
|link4='' | |link4='' | ||
| − | |prelink=[[ | + | |prelink=[[TUFLOW_Message_2336|Message 2336]] |
|uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] | |uplink=[[2xxx_TUFLOW_Messages|2xxx Messages]] | ||
| − | |nextlink=[[ | + | |nextlink=[[TUFLOW_Message_2343|Message 2343]] |
}} | }} | ||
Revision as of 16:10, 5 October 2018
TUFLOW Message
ERROR 2340 - Less than 8 attributes for 2d_bc file: <filename>
Alternate Message
NA
Message Type
ERROR
Description
The file being read into the 2D model (.tbc file) using the Read GIS BC == does not appear to be a 2d_bc format file. This has less than the required 8 attributes for this layer.
The primary reason for this to occur is that a 1d boundary layer (1d_bc) file is being read into the .tbc file and not into the 1d domain (.ecf file). If the filename contains the text 1d_bc the additional output File appears to be a 1d_bc file and not a 2d_bc is also included in the output message.
Prior to the 2016 version of TUFLOW the accidental reading of a 1d_bc layer into the 2D boundary control file .tbc could cause an ERROR 2056 to occur.
Suggestions
Check that the 2d_bc file has the correct attributes and if a 1D boundary is being specified, please read this into the 1D control file (.ecf) or within a Start 1D Domain --> End 1D Domain block of commands in the .tcf.
| Up |
|---|
 2xxx Messages
|