Flood Modeller Tutorial Model: Difference between revisions

This tutorial model has been developed by BMT with Jacobs. Please post comments, requests and feedback to [mailto:support@tuflow.com support@tuflow.com].

 

Both TUFLOW and Flood Modeller have relatively modest system requirements for small models such as the tutorial model. However, larger and more complex models may have higher hardware requirements - in particular memory (RAM). Both software are available in 32 and 64 bit versions.

==Hardware==

 

=Module Data=

*[https://downloads.tuflow.com/_archive/TUFLOW/Tutorial_Model/FMT_Tutorial_QGIS.zip QGIS Data Download]

*[https://downloads.tuflow.com/_archive/TUFLOW/Tutorial_Model/FMT_Tutorial_Data_MapInfo.zip MapInfo Data Download]

The aim of this tutorial is to demonstrate the steps undertaken to build, review and visualise the results of a linked Flood Modeller – TUFLOW model. It assumes that the user has a good understanding of both the 1D component of Flood Modeller and the 1D and 2D components of TUFLOW. The following resources may be of use:

*[[Tutorial_Introduction | TUFLOW Tutorial Model]]

*[https://www.floodmodeller.com/media/34731/isis_1d_quick_start_guide.pdf Flood Modeller 1D Quick Start Guide]

*[https://help.floodmodeller.com/docs Flood Modeller User Manual]

 

From this tutorial you will learn how to add a 1D pipe network and connect it to the representation of the watercourse created in Flood Modeller and link it to the TUFLOW representation of the floodplain created as part of [[Flood Modeller Tutorial Module01|Flood Modeller Tutorial Module 1]]. This tutorial is ideal for those who would like to learn more about the interaction of TUFLOW with Flood Modeller including the simulation of fully integrated drainage systems.